View Single Post
  #2   Spotlight this post!  
Unread 13-02-2006, 19:21
BradAMiller BradAMiller is offline
Registered User
AKA: Brad
#0190 ( Gompei and the Herd)
Team Role: Mentor
 
Join Date: Mar 2004
Location: Worcester, MA
Posts: 591
BradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant futureBradAMiller has a brilliant future
Re: CMUCam, Easy C, and Labview

Quote:
Originally Posted by JJMax7
I can't seem to get the camera to track the target through the code. It works fine in Labview, so I get the best image I can and save the config for Easy C. Than in easy C I initialize the camera, start the camera, and than just try to gather feedback to see if its working properly. I was able to get it working once, but now I can't seem to duplicate it. If anyone could give me any insight on something I may be overlooking, I would greatly appreciate it. Or if someone could possible give me a config that they got to work I could try that.
The default configuration in EasyC should be pretty close. That is any of the "slots" in the table where you don't set values should get you tracking the target.
__________________
Brad Miller
Robotics Resource Center
Worcester Polytechnic Institute