View Single Post
  #4   Spotlight this post!  
Unread 14-02-2006, 15:05
JJMax7 JJMax7 is offline
Registered User
None #0918 (Circuit Chargers)
Team Role: Driver
 
Join Date: Jan 2005
Rookie Year: 2005
Location: Oklahoma
Posts: 22
JJMax7 is an unknown quantity at this point
Send a message via AIM to JJMax7
Re: CMUCam, Easy C, and Labview

Did you convert Kevin's code into Easy C?

If I run the servos for the camera off the RC will the back up battery still need to be fully charged?

I was planning on running the servos off for ease of programming, since I don't have much time to test, but I can try to do it. I don't think I've been running the camera off a full back-up, I'll try that. I had thought that since it worked fine in Labview, and I had given the robot power via the RC and the back-up. I don't have any problem keeping a full back-up battery since we have a few, as well as chargers.

We set-up the camera properly. I made sure of that. I had it running once, so it could be the power problem. But thanks for all the help.