[EHaskins]

I was at a practice competition and our robot took a good hit to the camera. the camera was well protected but after that the camera would not work. when we finished that round i disconnected the camera from the robot and connected it to LabVIEW. i tried to grab frame but all i saw was purple with a two or three small blobs of green.

i had the camera board form last year with me so i put this years lens on the board and tried that with LabVIEW. It worked but when i tried to connect it to the robot it couldn't communicate.

is the 2005 camera not compatible with code for the 2006 cam? and how can i correct this .

is this just bad luck or are the cameras that fragile?