Thread: Dashboard Port Decoder
View Single Post
  #9   Spotlight this post!  
Unread 02-03-2006, 19:21
whytheheckme's Avatar
whytheheckme whytheheckme is offline
Registered User
AKA: Jacob Komar
no team
  
Join Date: Feb 2006
Rookie Year: 2005
Location: Providence, RI
Posts: 1,320
whytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond reputewhytheheckme has a reputation beyond repute
Send a message via ICQ to whytheheckme Send a message via AIM to whytheheckme Send a message via MSN to whytheheckme Send a message via Yahoo to whytheheckme
Re: Dashboard Port Decoder
After changing the code, I still get the Basic Run Err light. I tried disabling the Serin COMA/COMB and it still sees the operator interface and runs without it. I still get the Basic Run Err though. I also tried toning the Baud rate down.

Jacob Komar

Revised Comments:
If I remove ALL of the serin commands, I also get the Basic Run Err. Could this mean that it doesn't see the serin 16 as a valid command?
Last edited by whytheheckme : 02-03-2006 at 19:27.