[Rickertsen2]

Originally Posted by whytheheckme

OK!

I got the stamp to read values from the OI packet, so when I press the trigger, I can make the logic value of a pin high; when I let go, it will go to low. As soon as I move the jumper over to RC next to the dashboard port, and write my code to check the ctrl_a, b and c to suck a certain byte (PWM 1, for instance,) it isn't reading properly. For some bytes, only the lows will work, but when i try to switch it to a high, i get a 2.7 voltage, and other bytes are just 0 all the time. Any suggestions?


Jacob Komar

glad to hear it's working... at least a little bit

post the most recent code. I might have an idea about why it might not work

You seem to be on a good track with the BASIC stamp, so i'm not going to bother with the C code.