|
Re: Driving Contraint Error
The most likely thing that will happen is the part could:
1) Be over constrained (two constraints for the same thing)
2) It is causing other constraints to fail such as a pivot point wont move or a part is constrained not to slide when it should.
3) The two arts being constrained do quite match up right and are causing an alignment problem (.00000000000...000000000000001 in cad is too much off)
I would have to look at the file and see for myself what it is. But thanks for the picture it really helped.
__________________
WHAT TIME IS IT????? 279!!
2006 GLR Safety Award (2nd year in a row)
2005 National Xerox Creativity Award
2005 National Curie Quarter Finalist w/ 1126 and 180
2005 Buckeye Regional Champs w/ 67 and 274
2005 Buckeye Regional GM Industrial Design Award
2005 Buckeye Regional Safety Award
2005 GLR Quarter Finalist
2005 GLR Xerox Creativity Award
2005 GLR Safety Award
2004 Nationals Curie Division Finalist
2004 GLR Champs
2004 Buckeye Delphi Driving Tomorrow Award
2004 Buckeye Quarter Finalist w/ 1001 and 869
2003 GM Industrial Design Award GLR
2001 National Champs
|