View Single Post
  #9   Spotlight this post!  
Unread 09-03-2006, 23:08
TubaMorg TubaMorg is offline
Programmermechanicalelect ricalcoach
AKA: Dan
FRC #1480 (Robatos Locos)
Team Role: Mentor
 
Join Date: Jan 2006
Rookie Year: 2005
Location: Houston
Posts: 450
TubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond reputeTubaMorg has a reputation beyond repute
Re: HELP! We need pneumatic wiring help!

Quote:
Originally Posted by Don Rotolo
This will work fine. Last year we found a better solution, called a "Three-position pressure center" valve. The spec sheet is here. Look at valve type SY3520-6H, for example.

This kind of valve has three positions, and uses two solenoids: Position 1 is extend, Position 2 is hold, and Position 3 is retract. One solenoid is Extend, the other is Retract, and when neither is energized it means Hold. (This can and should be controlled with a single spike as explained by coffeeism above).

We selected "Pressure Center" types, which apply full pressure to both sides of the cylinder when in the Hold position. You can also choose "Closed Center", which closes off all air to the cylinder. You don't want "Vent Center", which will allow the piston to move freely in the "Hold" (center) position.

One important thing we learned last year: Pistons work best in 'this end or that end' applications - they do not work well for non-endpoint positioning. The problem is that any variation in load causes the piston to move, because it's only air, and that will often cause a problem.

Good luck. I hope this post helps anyone considering midpoint positioning of pneumatic cylinders.

Don
Whoa! Correct me if I'm wrong, but I thought the use of "alternative" solenoid valves is prohibited! How'd you get away with that? Of course there are valves out there that can control mid-stroke positioning, but we are only allowed to use the solenoids in the kit. You are right, though, that the compressability of air makes positioning pretty iffy...definitely no precision there without a more complex feedback mechanism (such as a pot).