|
Re: HELP!!!!!! LABVIEW IS MAKING ME MAD!!!!
You might want to take a lot at these PDFs that we created for user manual and to show the wiring for the CMUcam2 for the LabVIEW interface.
You can use the RC to provide power for the camera and drive the pan/tilt servos if you'd like but you can't simultaneously attach the RS232 cable to the camera from the PC and the TTL serial cable to the RC (the CMUcam2 won't know "who" to talk to). When using the LabVIEW app, you should only have the RS232 cable between the PC and the CMUcam2.
You should also confirm that you've downloaded and installed NI-VISA. The directions are included in the attached user manual.
That should get you going. Let me know if you need anything else.
Good Luck,
Russ
|