Quote:
|
Originally Posted by Exotria
I don't know about your team, but our motors use an autolocking system so that it's harder for us to be pushed. Thus, whenever a motor isn't receiving instructions, it locks itself up, so if certain motors are moving(say, two matching sides in a hex drivetrain design) while others aren't, the wheels wouldn't be rolling to go along with the miniwheels. Omniwheels wouldn't be very omni in that situation. And that's the point of my idea.
|
Are you talking about the brake/coast jumpers on the victors? You can set the jumpers on the speed controllers to short the motors with a neutral command (127), this causes them to brake. You can also set them to coast on neutral, which lets the motors free spin. The jumper block is right below the PWM cable port on the victor.