[Greg Perkins]

So this took me about 20-30 minutes to assemble, and for the last 40 minutes I've been diddling around with surfaces and Inventor Studio. Thanks Petek! If you've got inventor, it's really easy to do, just 2 parts and 1 assembly was all it took.

list of parts:
20 hex shape, .625" flats all around
12 Pentagon shape, .625" flats all around

When you go to constrain your parts, make sure you constrain (create in your mind a relative top and bottom to each part) to the bottom edge of each peice. that way when it bends into a icosahedron it will all fit.

Good luck!