|
Easy OmniTrack
Well I was board so I made an OmniTrack in Alibre Designs. It uses square aluminum tubing as the frame. Then i drilled some wholes in it and welded a few connector pieces on it, put in the shaft, bushings, and roller and here it is. The roller isn't perfect, I know, so try to focus on the shape of it.
I'm an extreme "I want to make something" state.
__________________
Finally in college =]
2009 Midwest Regional Champions - Thanks 111 and 1625
Last edited by Joe_Widen : 13-05-2006 at 15:15.
|