Thread: pic: How do you put an encoder on the FP Gearbox?
View Single Post
  #2   Spotlight this post!  
Unread 06-06-2006, 12:34
Richard Wallace's Avatar
Richard Wallace Richard Wallace is offline
I live for the details.
FRC #3620 (Average Joes)
Team Role: Engineer
  
Join Date: Jan 2003
Rookie Year: 1996
Location: Southwestern Michigan
Posts: 3,637
Richard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond reputeRichard Wallace has a reputation beyond repute
Re: pic: How do you put an encoder on the FP Gearbox?
Quote:
Originally Posted by JVN
I was asked to mount a Vex encoder onto a FP gearbox, so we could measure it's run-speed. It was a fun little challenge.
Nicely done, JV.

Since you had to cut the gearcase anyway, wouldn't it have been easier to mount a geartooth sensor near the motor pinion and just measure the electrical frequency of its signal? Or was the challenge specifically to do the job with a Vex encoder?
__________________
Richard Wallace

Mentor since 2011 for FRC 3620 Average Joes (St. Joseph, Michigan)
Mentor 2002-10 for FRC 931 Perpetual Chaos (St. Louis, Missouri)
since 2003

I believe in intuition and inspiration. Imagination is more important than knowledge. For knowledge is limited, whereas imagination embraces the entire world, stimulating progress, giving birth to evolution. It is, strictly speaking, a real factor in scientific research.
(Cosmic Religion : With Other Opinions and Aphorisms (1931) by Albert Einstein, p. 97)