|
Re: Axel Diameters
Quote:
|
Originally Posted by Booger
we used the high traction robot wheels and they work very good with our design. the only thing im having trouble wiht is trying to figure out how much bigger the hole needs to be where the shaft goes into the side plates
|
If it's a powered axle in bearings, you'll need to bore press fit holes large enough for the bearing outer diameter. If you're using a dead axle and you're not intent on being too precise (which seems to be the case), you ought to be fine by drilling out the hole with a drill bit the same diameter as your axle and then opening it up slowly by hand using a deburring tool or the like.
__________________
--Madison--
...down at the Ozdust!
Like a grand and miraculous spaceship, our planet has sailed through the universe of time. And for a brief moment, we have been among its many passengers.
|