[Goaliexam]

I've been having some major issues generating an Inventor part based on the attached drawing (PDF).

As the filename says, the drawing is the profile of a dome, so the part has to end up as a 3d dome.

I try my best to follow the dimensions as specified, but when I use the Revolve tool on the half-drawing I make, it always leaves a "seam". This is the first part design I've run into in the past two years that I haven't been able to model, so this is driving me crazy.

I would really, really appreciate it if someone could make the part and then attach it to this thread or email it to me (maxcutler@gmail.com).