Thread: Determining screw/thread size
View Single Post
  #1   Spotlight this post!  
Unread 31-07-2006, 22:03
NoodleKnight's Avatar
NoodleKnight NoodleKnight is offline
24 Hours of LeMons?
FRC #0100 (WHS&CHS Robotics)
Team Role: Alumni
  
Join Date: Aug 2004
Rookie Year: 2003
Location: Davis, CA
Posts: 320
NoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud ofNoodleKnight has much to be proud of
Send a message via AIM to NoodleKnight
Determining screw/thread size
Is it possible to do without a thread gauge?
Like, could I use calipers to figure out a certain dimension then plug it into a formula to get the answer i'm looking for (like for determining gear pitch).
__________________
WHS/CHS Robotics - Team 100 (2003-2006):
2006- Delphi's Driving Tommorow's Technology @ Davis | Imagery Award @ SVR | 2004- SVR Finalists (w/ 691 and 1280)| 2003- Delphi's Driving Tommorow's Technology @ Sac