View Single Post
  #32   Spotlight this post!  
Unread 15-08-2006, 12:29
Kevin Sevcik's Avatar
Kevin Sevcik Kevin Sevcik is offline
(Insert witty comment here)
FRC #0057 (The Leopards)
Team Role: Mentor
 
Join Date: Jun 2001
Rookie Year: 1998
Location: Houston, Texas
Posts: 3,764
Kevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond reputeKevin Sevcik has a reputation beyond repute
Send a message via AIM to Kevin Sevcik Send a message via Yahoo to Kevin Sevcik
Re: CIM Voltage and Motor Suggestions

Here's a link to some on McMaster Carr

Drill shaft goes in one side, wheel shaft goes in the other. As you can see, the coupling istelf is only held together if it's pushed from both sides. If you try to bend it or anything it'll just fall apart. So. You mount the drill with that clamp on one side, and then you'll need two bearings supporting the wheel's shaft on the other side.
__________________
The difficult we do today; the impossible we do tomorrow. Miracles by appointment only.

Lone Star Regional Troubleshooter