|
Re: New AndyMark Shifters!
[quote=Andy Baker]Yes, we will have one ready. It's just not on the site yet. The tricky part to converting from pneumatic to servo shift would be swapping out the small "shift shaft" that is connected to the dog gear by a 3/32"x1" roll pin. If you're good at removing that roll pin, then it will be easy.
[quote]
Shouldn't be a problem. When we built dog shifters for the first time in '04 it took a few attempts to get things right  so we have experence.
I'm getting the 404 on gifts also, but I got my t-shirt already. Just another reason to drive halfway across the country to go to IRI.
__________________
2011 Championship Finalists/Archimedes Division Championships w/ 2016 & 781
2010 Championship Winners/Newton Division Champions
Thank-you 294 & 67
2009 Newton Division Champions w/ 1507 & 121
2008 Archimedes Division Champions w/ 1124 & 1024
2007 Championship Winners/Newton Division Champions w/190, 987 & 177 The Wall of Maroon
2006 Galileo Division Champions w/ 1126 & 201
www.bobcatrobotics.org
"If you can't do it with brains, it won't be done with hours." - Clarence "Kelly" Johnson
|