[Greg Needel]

Originally Posted by Andy Baker

Thanks for all of the input everyone.

We will decide this coming week if there will be variations. Here are the options we are considering:

8" Performance Wheel w/ 1/2" hex hole
6" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)
8" Performance Wheel w/ 1.1245" bore for 1/2" id bearings (one on each side)

These would be a MAYBE at this point. Providing an appropriate amount of intentory on all of these parts is our biggest challenge.

Andy B.

Also just for people FYI you can get 3/8 bearings that have an od of 1.125 so these would be capiable of use with the kit frame.