Quote:
Originally Posted by Tytus Gerrish
only if you have the equipment to do it. Namely the proper size drill, reamer ir adjustable boring bar. and then of course the clamping hardware to hold it Dead center for a proper concentric hole.
So in effect Mr. Jimmy on team XXX with No Lathe, Mill Tooling, or Indicator to even be able to center it on a drill press cant just bore it out
|
You could do it on a drill press if you were very careful. Even if you weren't all that careful, you could get close enough that it'd still work.
Assuming you have a drillpress--chuck up a length of 1/2" hex shaft. Slide wheel onto shaft, and clamp in place on the table. Unchuck the hex shaft, get out your drill, and have at it.