View Single Post
  #18   Spotlight this post!  
Unread 26-12-2006, 17:49
chris31 chris31 is offline
Team 2021 Captain
AKA: Chris Davidson
FRC #2021 (FA Robotics)
Team Role: Mentor
 
Join Date: Nov 2005
Rookie Year: 2006
Location: Atlanta, GA/ Fredericksburg,VA
Posts: 949
chris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond reputechris31 has a reputation beyond repute
Send a message via AIM to chris31
Re: How would I interface a flash drive to the RC?

Quote:
Originally Posted by JBotAlan View Post
OK, I'll have to give some of these solutions a try.

Good point about the weight issues. I know every year we are at least .2lbs overweight...a little PIC board and flash drive are surely seen as expendable and will be ripped off ("Jake, are you sure we need that?").

I'll have to look at how big our EEPROM is; I might be able to just use that--even though using a PIC with an SD card or CF would be the funnest (wow, spell check isn't whining about the word "funnest") project.

Thanks for all your suggestions,
JBot
If you run it off teh dashboard port then it wount be any weight to the robot.