Quote:
Originally Posted by xrabohrok
The one from last year has pins for the servos to plug into, and the new one has no servo pins at all, the things at the bottom of this year's camera are solderable jumper settings (I think).
|
Wow, I didn't even look at the camera yet, so I haven't seen the missing servo outs. However, Kevin's code doesn't use them, rather, it uses PWM outputs from the RC itself to drive the two servos. You will have to open some of his code, I believe, to figure out which to plug into. Your programmer needs this info (if you're not the programmer).
Those docs should still be valid with this year's camera; it just sounds like they short-cutted and skipped the servo outputs that we weren't supposed to use anyway. I'll post back tomorrow after I've had a chance to look at the camera in person and make sure it is the same.
JBot