Quote:
Originally Posted by Stud Man Dan
That bot looks solid, just as I had expected from the new tytus+dillard+1889 team.
That arm looks really long does that front piece roll down, or stay in its original position? Just make sure it doesn't go outside that 72" zone or otherwise it'd be bad news.
It'll be fun to see you guys at Florida.
|
Thanks Dan.
The arm deploys at the elbow, once (spring loaded) such that the upper and lower arm sections are co-planar (co-linear in side view). That joint is just to stay within the 48 inch high envelope. The kinematics of the remaining joints use idler sprockets to ground such that the end effector always points in the same direction (into the robot as shown, away from the robot when rotated into position at the front (left in this picture). The gripper fingers (outboard red pieces) are actuated.
We prototyped the arm today; the gripper works better than I had hoped. The remaining kinematics were a little rough because of some prototyping shortcuts we took, but I've used this mechanism before and that's not a concern.
As for the 72 x 72 envelope, it fits in diagonally with Angstroms to spare, thanks to the narrow aft face of the frame which gives us an additional 5 inches of effective length. Besides, I'm sure Woody would let us use it even if it violated the rules; after all, we've put alot of engineering time into it.
