|
Re: Attempting to Cut BaneBot 56mm Shaft
It's quite easy to remove the output shaft from the gearbox.
Remove the 4 2.5mm hex head screws around the periphery of the geabox on the output side, and pull the output side endcap off. You can then undo an external retaining clip on the inside end of the shaft, and pull the shaft off.
__________________
Jerry Skene, mentor OOO OOO 2010 - Chairman's Award- DC OOOOOOOOOOOOOOOOOOOOOOOOOOO
Chantilly Academy, Team 612 - 2009 - Engineering Inspiration Award; Finalist - New Jersey
-----------------------------------2008 - Chairman's Award; Kleiner Perkins Award -Buckeye ---| ---Team Spirit Award - NASA/VCU
-----------------------------------2007 - Chairman's Award - NASA/VCU ---| ---Finalist; Kleiner Perkins Award - Chesapeake
-----------------------------------2006 - Chairman's Award - Chesapeake ---| --- Engineering Inspiration Award - NASA/VCU --
|