Thread: Configuring Labview code to easyC
View Single Post
  #1   Spotlight this post!  
Unread 15-01-2007, 13:17
team877's Avatar
team877 team877 is offline
Registered User
FRC #0877 (Cub Robotics)
Team Role: Programmer
  
Join Date: Jan 2007
Rookie Year: 2001
Location: North Dakota
Posts: 52
team877 is an unknown quantity at this point
Configuring Labview code to easyC
Hi there, after lots of troubleshooting I got to where i should save labview to easyC code and when i did that it did not save it as a .ECC file it saved it as a configuration setting. Therefore when i tried to run it on easyC it wasnt there. If you can help me settle this problem it would be greatly appreciated.





Thank you....
Adam, Programming
Reply With Quote