Quote:
Originally Posted by Uberbots
if you load your tube so that it is parallel to the floor, you can essentially load it at any angle. I'm not sure if this should be posted here, but you asked the question. it really is a bad idea to mount it dead on... there are too many accuracy woes to worry about.
|
This is exactly what I am pushing for. However, I am on a robotics
team, and if the rest of the team decides that the other alternative on the drawing board (a gripper claw that grips from the inside, and loads perpendicular to the floor) is better/easier to make, then so be it. It becomes a software problem. I should know my fate by tomorrow afternoon.