[Kevin Watson]

Originally Posted by 114Klutz

Here's my current configuration - I have the CMUCam2 connected to the programming port with a M/M Serial Cable. Over the TTL connection it works perfectly, however, over the programming port, it doesn't. The servos center, the lights are on, both of them, on the CMUCam2. This is normally indicative of no camera signal.

I connected the programming port to my laptop, and ran a terminal program. I repeatedly received the CR?>, which I assume to mean camera ready? message. I am not receiving anything else, such as printf debug messages; so that can not be the cause of failure. I have tested the camera over the serial port with the java application, it also works fine.

I'm out of places to look, I reset the robot controller multiple times, and the voltage on the backup battery was 8.2 volts. I went through the FAQ already.

If you want, zip-up your code and send it to me and I'll have a quick look this evening.

-Kevin