[agrahimi]

We called IFI and they had a solution. We did this a while ago so the steps may not be exact but I recommend you try these steps:

1. Unplug battery/power and plug back in
2. Hold down the PROG and RESET buttons on the RC for about 15 seconds then let go of RESET and continue to hold PROG until the green light turns from blinking to solid. At this point release PROG. (I may have the buttons backwards so check other threads/try the reverse if that doesn't work)
3. connect the programming cable to the pc and open the MASTER file. This is a .BIN file so you will need to switch file type in the file browser. If you do not have this file download it from IFI's site.
4. Make sure that the OI is plugged through Tether into the RC so both units are on.
5. Press download
6. The master code should go over. If it doesn't check your settings and call IFI
7. If it does, proceed to send over the default code.
8. You should be fixed, worked for us, good luck to you!