Thread: Globe Motors
View Single Post
  #11   Spotlight this post!  
Unread 21-01-2007, 16:53
MrForbes's Avatar
MrForbes MrForbes is offline
Registered User
AKA: Jim
FRC #1726 (N.E.R.D.S.)
Team Role: Mentor
 
Join Date: Feb 2006
Rookie Year: 2006
Location: Sierra Vista AZ
Posts: 6,013
MrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond repute
Re: Globe Motors

Thanks, I was at the hardware store, a 1/4" id x 5/8" od ball bearing is readily available, and since it's od is the same as the end of the motor, it should be possible for us to make two plates that will keep it all in line relatively easily.

If the chain will fit in the available space, and leave room for mounting the sprocket, that is.....