Thread: pic: IFI Charger Parts Layout
View Single Post
  #4   Spotlight this post!  
Unread 25-01-2007, 18:53
Dad1279 Dad1279 is offline
Registered User
FRC #1279 (Cold Fusion)
Team Role: Mentor
  
Join Date: Jan 2005
Rookie Year: 2004
Location: NJ
Posts: 511
Dad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud ofDad1279 has much to be proud of
Re: pic: IFI Charger Parts Layout
Good point. If etching a board I would make the paths wider. We did not make a board from this, the intent was to use it as an aid for laying out the parts on a breadboard. It is easier to visualize, and the 317 terminals are not intuitive.
Reply With Quote