You should change the coil to 12 VDC.
* You must remove the 24V coils from the solenoid valves and replace them with the grey 12V coils before installing them on your robot. This is done by removing the mounting screws, and switching the 24V coils for the 12V coils provided. More information about these valves is provided in the FIRST 2007 Pneumatics Manual posted on the FIRST website:
http://www2.usfirst.org/2007comp/oth...s%20Manual.pdf
The SMC Pneumatics kits have been sent to your team’s Shipping Contact as entered in your TIMS record. The contents of the kits are listed below:
- QTY 1: Straight fitting, male, 5/32" tube, 1/8 NPT (PN KQ2H03-34S)
- QTY 1: Elbow fitting, 90, 5/32" tube, 1/8 NPT (PN KQ2L03-34S)
- QTY 5: Elbow fitting, 90, 1/4" tube (PN KQ2L07-34S)
- QTY 10: Straight fitting, 1/4" tube (PN KQH07-34S)
- QTY 10: Elbow fitting, 90, 1/4" tube (PN KQLO7-35S)
- QTY 5: Tee union, 1/4" tube (PN KQTO7-00)
- QTY 6: Flow control (PN NAS2201F-N01-07S)
- QTY 2: Sub base, 1/8” ports (PN SY3000-27-1T)
- *QTY 2: Double solenoid valve, 24VDC (PN SY3240)
- *QTY 1: Single solenoid valve, 24VDC (PN SY3140)
- *QTY 5: 12VDC replacement coils (PN SY114-6LOZ)