Thread: Removing the stock pulley from the 3" CIM
View Single Post
  #3   Spotlight this post!  
Unread 28-01-2007, 18:30
Arefin Bari's Avatar
Arefin Bari Arefin Bari is offline
Registered User
AKA: Ari
FRC #0108 (SigmaC@T)
Team Role: Engineer
  
Join Date: Mar 2003
Rookie Year: 2001
Location: Ft. lauderdale, FL
Posts: 3,243
Arefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond reputeArefin Bari has a reputation beyond repute
Send a message via ICQ to Arefin Bari Send a message via AIM to Arefin Bari Send a message via MSN to Arefin Bari Send a message via Yahoo to Arefin Bari
Re: Removing the stock pulley from the 3" CIM
Quote:
Originally Posted by CMICK View Post
I'm trying to remove the pulley that comes on the big CIM motor. It looks like it is made for a belt. I know this has been talked about before on this board but I couldn't find the previous post.

I took the set screw out and put a small gear puller on the pulley but it won't budge.

Anybody have a hint for me?

Thanks for any help.
This gear puller does wonders. After you take the set screw out from the pulley, you have to heat it up, then use this gear puller to pull the pulley out slowly. Good luck.