Thread: Removing the stock pulley from the 3" CIM
View Single Post
  #6   Spotlight this post!  
Unread 29-01-2007, 03:20
Kirk Kirk is offline
Registered User
FRC #0254
Team Role: Engineer
  
Join Date: Jan 2002
Rookie Year: 1997
Location: Woodside, CA
Posts: 97
Kirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud ofKirk has much to be proud of
Send a message via AIM to Kirk
Re: Removing the stock pulley from the 3" CIM
Assuming you don't want to use the pulley these work great. Just tighten up the bolt and the pulley will crack in half. Doesn't risk damaging the motor with heat or any pulling.

You can get them at most hardware stores like sears. Home Depot might even have them. Look under nut splitters. Best of all they are CHEAP.

http://www.harborfreight.com/cpi/cta...emnumber=40929