Quote:
Originally Posted by jdejoannis
I am having a similar problem with both pan and tilt not exploring the full range of motion. The camera likes to look up and to the right. Are there some calibration settings for the servos? We are using the default bells and whistles code, the 2007 camera and the 2006 pan/tilt assembly.
Jason
|
You can use the code discussed
here to drive your servos past the range the RC would normally provide by using gains higher than 50 (5.0us). Towards the end of the thread I discuss a method to precisely tune the range and center position of your servo(s). I found that I needed a gain of 36 to rotate the servo shaft 90 degrees, which implies that you need around twice that to get the full range.
-Kevin