Thread: Banebot 56mm gearbox - double D - RELOADED
View Single Post
  #19   Spotlight this post!  
Unread 01-02-2007, 13:41
Joe Johnson's Avatar Unsung FIRST Hero
Joe Johnson Joe Johnson is offline
Engineer at Medrobotics
AKA: Dr. Joe
FRC #0088 (TJ2)
Team Role: Engineer
  
Join Date: May 2001
Rookie Year: 1996
Location: Raynham, MA
Posts: 2,633
Joe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond reputeJoe Johnson has a reputation beyond repute
Re: Banebot 56mm gearbox - double D - RELOADED
Quote:
Originally Posted by Daniel_LaFleur View Post
Joe,

The material stated on your drawing. Is that the material we should make it out of, or the material it was made out of?
There are many mat'ls that will work. I recommend that you talk to your source and pick one that has a RC23 hardness out of the shoot (i.e. without heat treating). The mat'l on the print is what I would do if I wanted to end up with a RC40 or so part. But you can relatively easily machine RC23 parts (or I should say, some machine shops can). Talk to the source about what they can get easily. If the mat'l is RC23 or higher, it should be fine.

Joe J.
__________________
Joseph M. Johnson, Ph.D., P.E.
Mentor
Team #88, TJ2