Quote:
Originally Posted by enpurx
Thank you I hadn't realized that, its helping but it still seems to be leaking, is the valve supposed to be assembled pointed piece>spring holder>spring>then finally end cap? I think the reason it may be leaking is because A. its assembled wrong, or B. there is dirt pushing that pointed piece up from the hole... Does this seem like reasonable possibilites, and did I assemble the valve right?
|
Not sure I understand how you connected it, but here's what the
pneumatics manual says:
Quote:
|
Originally Posted by 2007 FRC Pneumatics Manua
Look at the top of the regulator. You will note that one port extends out a little bit more than the others. It
also has an arrow on it to denote the outlet of the regulator. The opposite port is the inlet. A pressure gauge may
be placed in either of the other ports. You will have to plug the other gauge port with the enclosed hex plug.
|