View Single Post
  #82   Spotlight this post!  
Unread 07-02-2007, 14:42
MrForbes's Avatar
MrForbes MrForbes is online now
Registered User
AKA: Jim
FRC #1726 (N.E.R.D.S.)
Team Role: Mentor
 
Join Date: Feb 2006
Rookie Year: 2006
Location: Sierra Vista AZ
Posts: 6,028
MrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond repute
Re: Banebot 56mm gearbox - double D - RELOADED

Quote:
Originally Posted by ZZII 527 View Post
Something to press the pins out will be useful too...a table top drill press can probably work.
If the new plates don't have pins in them, you can quickly remove the pins from the old plate with a 1/8" pin punch (or a 16d nail with the point ground off), a hammer, and a small socket from a socket wrench set.

Installing them can be done with a vise or the hammer, but it would be nice to have a guide, such as a chunk of 1/4" or so thick aluminum with a slightly oversize 4mm hole in it, drilled as close to 90 degrees as you can get it.