|
Re: Angled holes?
I take back my advice on using the sweep command in this particular case because though you are cutting a circle, it is an ellipse on each surface. Unless you want to draw the ellipse, you can not use the sweep or loft. I would have to agree with others when they say to use the rotated work plane with extrude.
__________________
"Curiosity. Not good for cats, great for scientists."- Numb3rs
"They can break your cookie, but... you'll always have your fortune."-T.W. Turtle, Cats Don't Dance
"Tell my tale to those who ask. Tell it truly - the ill deeds along with the good, and let me be judged accordingly. The rest... is silence."-Dinobot, Beast Wars
"Though the first step is the hardest and the last step ends the quest, the long steps in between are certainly the best."
–Gruffi Gummi, Disney's Adventures of the Gummi Bears
|