[Cody Carey]

Hello everyone, I was just cleaning up the user code for this years 'bot, but I did it in notepad... so I'm not completely up on the syntax. I looked over it the best I could, but I would like some help so that I don't have to debug it when I go in on Monday. I would also like to know If I am using "SetRelay" correctly, and if there is anything that is done just plain sloppy/ how to fix it. Any help would be GREATLY appreciated

Thank you,
-Cody C.

unsigned char check;
unsigned char topcheck;


\*---------------------------ramp control-------------------------------*/

if (p3_sw_top == 1 && topcheck == 0);            // Press top button, kick cylinder extends; press top button cylinder retracts
     
    {
    SetRelay ( 2 , 1 ,0 ) ;
    topcheck==1; 
    }


else if (p3_sw_top == 1 && topcheck == 1);        
     
    {
    SetRelay ( 2 , 0 ,1 ) ;
    topcheck==0; 
    }


if (p3_sw_trig == 1 && check == 0);              // Press trigger... Hippo folds down and ramp folds out; Press again, reset.
     
    {
    SetRelay ( 3 , 1 ,0 );
    SetRelay ( 4 , 0 , 1 );
    SetRelay ( 5 , 1 ) ;
    check==1; 
    }


else if (p3_sw_trig == 1 && check == 1);
     
    {
    SetRelay ( 3 , 0 ,1 ) ;
    SetRelay ( 4 , 1 , 0 );
    SetRelay ( 5 , 0 ) ;
    check==0; 
    }


/*----------------------------Arm control------------------------------------*/


if (p4_sw_aux1 == 1);                 // if top red switch is up, Hippo is up and Jaw is closed
    
    {
    SetRelay ( 4 , 1 , 0 ) ;
    SetRelay ( 5 , 1 )
    }

if (p4_sw_aux1 == 0);                // if top red switch is down, Hippo is down and Jaw is open
    
    {
    SetRelay ( 4 , 0 , 1 ) ;
    SetRelay ( 5 , 0 )
    }

if (p4_sw_aux2 == 1);                // if bottom red switch is up, Hippo is down and Jaw is closed (ramp down)
    
    {
    SetRelay ( 4 , 0 , 1 ) ;
    SetRelay ( 5 , 1 )
    }



/*-------------------------Shifting-------------------------------------------*/



if (p4_sw_top == 0 && p3_sw_trig == 0);        // if shifter is in Bottom position, servos are in position 1
     
    {
    pwm05=0; 
    }


if (p4_sw_top == 1 && p3_sw_trig == 0);        // if shifter is in Middle position, servos are in position 2
     
    {
    pwm05=127; 
    }

if (p4_sw_top == 1 && p3_sw_trig == 1);        // if shifter is in Top position, servos are in position 3
     
    {
    pwm05=255; 
    }