Thread: HELP: analog input
View Single Post
  #9   Spotlight this post!  
Unread 18-02-2007, 19:27
EHaskins EHaskins is offline
Needs to change his user title.
AKA: Eric Haskins
no team (CARD #6 (SCOE))
Team Role: College Student
  
Join Date: Jan 2006
Rookie Year: 2006
Location: Elkhorn, WI USA
Posts: 998
EHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond reputeEHaskins has a reputation beyond repute
Send a message via MSN to EHaskins
Re: HELP: analog input
I have been having the exact same issue. I tried IFI's ADC, Kevin Watson's integrated into my code, Kevin Watson's from his website(unmodified), and whatever EasyC uses.

They all read 0.

I have tried both the 2006 and 2007 controllers.

I have the pot connected so the 5v+/gnd each connect to one side of the pot, and the signal is connected to the middle connector on the pot.

If I short the gnd/sig pins the reading does NOT change.

I have used Kevin Watson's ADC without any issues before now. I have run it on VEX, EDU, and 2005 controllers.

I was at the Sussex mini-regional today and talked to 4-5 other programmers, and none of them had any ideas.

What am I missing?

Thanks,
Eric Haskins
__________________
Eric Haskins KC9JVH