Quote:
Originally Posted by simeon1770
ok,
1.how does the secondary regulator, and the flow control valve look? picture? also how do u set it to 32 psi?
2. how do i turn the spike off, even when thespike wasnt hooked up in a pwm slot it was still sucking, but notihave it in digital output 1
|
The secondary regulator is a hardware device put in series with the solenoid in the line, before it. It has a physical knob you use to set the pressure. That should be in the Pneumatics manual.
You shouldn't have a solenoid valve hooked up to a digital I/O pin; it should be on a relay output. Then to turn on the vacuum cups you do something like
relay2_fwd=1;
relay2_rev=0;
And to torn them off you do something like
relay2_fwd = relay2_rev = 0;
I hope this helps,
Ari.