[Japper]

The dashboard viewer displayed that the RC was working and all control lines were functioning but it would not change the spikes. The RC unit would not switch (control) the spikes so we replaced it. (and yes the code hex file was downloaded a few times but still no cigar).

After loading the new RC with the same code, the new RC would control the spikes but then, the OI started acting funny and would not map the joysticks correctly. For example, the port 3 joystic X position displayed as the Y position on the dashboard viewer and the p3 wheel reported as the joystick x..... so we had to swap the OI out also...

I am left wondering if the replacement RC and our original OI were not compatible for some reason but the IFI guy said that they should work...

The hardware problems that we faced with the RC & the OI modules was a bad experieince which kept us from getting any practice and left our rookie team at an extreme advantage...