|
Re: 56mm Banebot problems @ Championship
We had the 56mm Banebot transmissions on our 6 wheel drive
robot, using the two motor adapters and 12:1 gear ratio.
We competed at three regionals and the nationals, with some
very aggressive defensive play at times.
We replaced the carrier plates and shafts with 4130 steel,
using a square drive for broach cost reasons, that we heat
treated in our shop and had no problems with our transmissions.
We also broke the transmissions in with no load, in both directions,
and then fully cleaned and lubed them prior to any hard use.
I think that Banebots needs to give some careful attention
to the details on the carrier plate and output shaft, and
these transmissions will be just fine for next year.
Eugene
|