Quote:
Originally Posted by Budda648
Heh... I remember in 2005, I think, we tried to do this but none of the engineers could get it to work. I suppose we'd use the 2005 and 2007 robots for demonstrations again, so I'd be interested in a detailed, step-by-step instruction on how to do this. Anyone know where to find instructions or care to describe it via PM for me?
|
Page 17 -
http://ifirobotics.com/docs/oi-ref-guide-1-30-07.pdf
Steps for changing channels:
1. Set the MSB of the Team Number Dipswitch to Open. This will set the Team Number greater than 2048.
2. Make sure both units (RC and OI) are set to the same Team Number by tethering.
3. Remove tether after a Link has been established.
4. Set the CHANNEL dipswitch to the desired channel.
5. Press OI RESET on the Operator Interface.
6. Press RESET on the Robot Controller.
7. Note: ROBOT RESET on the Operator Interface will not work for this.
8. After a few seconds, the “Valid RX” LEDs should be flashing on both units, indicating each is transmitting and receiving good data with the correct team number and channel number – a Link has been established.