Thread: Vex Programming Question
View Single Post
  #12   Spotlight this post!  
Unread 08-07-2007, 18:41
ManicMechanic ManicMechanic is offline
Registered User
AKA: Yolande
VRC #0438 (Metal Gear)
Team Role: Mentor
  
Join Date: Dec 2005
Rookie Year: 2003
Location: CA
Posts: 213
ManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond reputeManicMechanic has a reputation beyond repute
Re: Vex Programming Question
Quote:
Originally Posted by 1885.Blake View Post
KingofI337 says below (thank you King) that older versions of EasyC had a hidden linkage between PWM Control and whether or not the microcontroller (plus the implied receiver...) detected a valid signal from a transmitter. He says this is gone from more recent Vex EasyC versions.

.............

So, for purely autonomous operation (no Transmitter needed) I think you remove all PWM Control commands and replace them with Motor/Servo Module commands.
We're using the EasyC v2.0 upgrade, and we're not able to run autonomous programs with motor module commands unless we turn on the transmitter. I don't know if purchasing v2.0 from scratch produces better results.
__________________
He is no fool who gives what he cannot keep to gain that which he cannot lose. - Jim Elliot