Thread: How do you wire the wheel encoders?
View Single Post
  #2   Spotlight this post!  
Unread 17-07-2007, 14:56
jgannon's Avatar
jgannon jgannon is offline
I ᐸ3 Robots
AKA: Joey Gannon
no team
  
Join Date: Feb 2004
Rookie Year: 2004
Location: Pittsburgh, PA
Posts: 1,467
jgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond reputejgannon has a reputation beyond repute
Re: How do you wire the wheel encoders?
The gear tooth sensors can be used as encoders if you put them near a gear or sprocket in your drivetrain. This document will tell you how to wire them up, and also will point you to other documents with application notes:

http://www.ifirobotics.com/docs/2006...h-sensor-b.pdf
__________________
Team 1743 - The Short Circuits
2010 Pittsburgh Excellence in Design & Team Spirit Awards
2009 Pittsburgh Regional Champions (thanks to 222 and 1218)
2007 Pittsburgh Website Award
2006 Pittsburgh Regional Champions (thanks to 395 and 1038)
2006 Pittsburgh Rookie Inspiration & Highest Rookie Seed

Team 1388 - Eagle Robotics
2005 Sacramento Engineering Inspiration
2004 Curie Division Champions (thanks to 1038 and 175)
2004 Sacramento Rookie All-Star
_