I've been waiting for the release of this machine since I found out about it month ago.
There is a one page article in the Sept. issue of Pop Sci about it.
They predict each .1" layer will take 2 minutes to make!
I'm not sure if thats a typo, but that is very impressive if it can work that fast.
This is a quote from the article:
"fabricate for example, your own rubber watchband or
iPhone case."
I've already done that!
www.printo3d.com/iphonecase.html
Here is a fab@home printing chocolate!
http://youtube.com/watch?v=2speojl2P-Y
I broke the blade grips on my micro helicopter after a crash a few weeks ago.
This was the repair:
http://rchelimag.com/forum/attachmen...achmentid=2249
A 3D printing contest for CD may be in the works so stay tuned!
EDIT:
http://www.popsci.com/popsci/technol...cbccdrcrd.html
http://popsci.typepad.com/how20blog/...nters_gal.html