Thread: Need pinout for tether adaptor
View Single Post
  #2   Spotlight this post!  
Unread 23-06-2002, 21:55
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Need pinout for tether adaptor
Posted by Jeremy M. Husic, Engineer on team #47, Chief Delphi, from Ponitac Central High School and Delphi Automotive Systems.

Posted on 3/1/99 9:57 AM MST


In Reply to: Need pinout for tether adaptor posted by Paul Michalczuk on 2/28/99 7:56 PM MST:



: Help! I need to know if the tether adaptor that came with the kit is basically a gender changer or do I have to make a connector box for it?? If i have to make one, anyone know the pinouts??? I seemed to have misplaced it.
: Thanks in advance.

The tether adaptor passes three pins between two 9-pin D-Sub female
connectors. The pin map is as follows:

1 Not connected between the two connectors
2-------3 Note flipping of pins!
3-------2 Note flipping of pins!
4 Not connected between the two connectors
5-------5 Ground pass through
6 Not connected between the two connectors
7 Not connected between the two connectors
8 Not connected between the two connectors
9 Not connected between the two connectors

Hopes this helps.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.