Quote:
Originally Posted by ManicMechanic
|
Unfortunately, it contains a rather major error.
For the Chin-upbot, (project #2), under "Parts to cut", the instructions for cutting of angle bars are wrong.
The INCORRECT version currently reads:
Cut 3 X 15” angle bars into 2.5” + 12.5” (on the notch) – only the 2.5” pieces are used
Cut 1 X 15” angle bar into 5” + 10” (on the notch) – only the 10” piece is used
The CORRECT version should read:
Cut 3 X 15" angle bars into 5" + 10" (on the notch) - only the 5" pieces are used
From one of the remaining 10" pieces, cut one 7.5" piece (on the notch -- this is the center section)
My apologies -- I hope the error doesn't cause too much frustration & wasted metal. In our eagerness to start on the Challenge, we were a bit hasty in wrapping up this project.