Thread: The Perfect Design
View Single Post
  #5   Spotlight this post!  
Unread 23-06-2002, 21:56
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Not perfect ;-) There is no PERFECT design in my view
Posted by David, Student on team #269, BruQuest, from Oconomowoc High School and Quest .

Posted on 3/3/99 5:51 PM MST


In Reply to: The Perfect Design posted by Dan on 3/2/99 8:59 PM MST:



OK, here is what I have to say:
Our robot used a system to climb the puck that would allow it to climb
the puck even with your robot on it. It's not easy to explain. Basically
we climb the puck and then not completely on it just raise our backwheels
to be off the ground. (We don't use the poles though... it worked really
good. We had only one match at the Midwest Open, not ending up on the puck)
Our design also lets us move the puck while being on it, we just have to
raise the backwheels to again be off the ground. So your robot would allow
us to get the 2-multiplier and the 3-multiplier for being on the puck.
but your idea is not bad though ;-)
CYA
David


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.