Thread: I Need Help with downloading Basic Stamp Program
View Single Post
  #1   Spotlight this post!  
Unread 23-06-2002, 21:57
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
I Need Help with downloading Basic Stamp Program
Posted by Joseph, Other on team #252, Bay Bombers, from Broadway High School and NASA.

Posted on 3/4/99 10:06 AM MST



I have modified the Basic Stamp program that comes with
the control box. When I use the command to send the
file alt R I keep getting the message.
"Hardware not found"
I have tried to down load the
program with two different PC's using the COM port.
Initially I used the standard file transfer cable
provided with the PC's. I also built a cable based on
spec's provided on the First SW floopy that came with
the kit. I am using Stamp2. I have gone through and
checked the device drivers and COM systems and am fairly
sure that both PC's are operating correctly. I have used
the COM port on one the the pc's before with no problem.
I really need help. Please alpha page me if you have
any ideas.
Mark Joseph
800-774-9737



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.